|
Painless Wiring, Connect An Amp With A Cable Kit Easily
by: Amanda Leer
|
|
|
|
|
How to Install an Amp Kit? Amplifier wiring is a difficult task. With wiring kits this work can be done much easier. Still some work has to be done for attaching everything and you can go wrong. This wiring kit costs lower than the cost of the individuals.
The first thing to do before starting is the disconnection of the battery of the car. First the negative then the positive terminal is removed. If there is any hole in the heat shield coating in the car then use it. Or else make a small hole that is big enough to fit the power wire and heat protective wire cover.
The things needed to do this job are wire stripper, soldering gun , drill which is optional, a wrench that is adjustable and a screw driver. Keep these things ready before starting the work . Let us look at the steps in detail.
After this the wire is pulled near the back seat. Then from the back seat bring it to the trunk of the car by pulling it through the small holes in the seat. When the wire reaches the car's trunk, it is connected to the amplifier's positive terminal. Any excess wire is cut off. The wire is connected to the amplifier by using screws.
The trunk's carpet is lifted to find the frame. A bolt is identified. It is loosened and the ring is soldered on the ground wire. The bolt is again tightened. The other side of the ground wire is connected to the negative terminal. The color coded ends of RCA wire are connected to the appropriate color outputs of the stereo receiver. RCA wire is run along the opposite side of the power wire. RCA is fed through the rear seats, trunk and then it is connected to the amplifier.
Small remote wire is connected to the remote output at the back of the receiver which is blue in color. Twist them together to connect each other and use electric tape for safety. The wire is run alongside and connected between the negative and positive terminals. The speaker wires are connected to the speakers and the amplifier. One end of the speaker wire is connected to the amplifier's positive speaker wire. The other end is connected to the speaker's positive terminal. Panelling screws are tightened provided the wires running underneath are not damaged.
Now the speakers are connected to the amplifier through wires and the wires are connected in the amplifier based on the terminals. Later all the screws are tightened for a secure system. The fuse is removed from its place and the power wires are connected. After this the fuse is replaced back in its position.
Hence one should know how to install an amp kit.
Keywords: cars_and_rucks,cars,cable,kit,wiring,amp,amplifier,powernetshop.at
Article Resource
Author: Amanda Leer
About the Author:
Looking to find the best deal on Auto Hifi, then visit www.powernetshop.at to find the best advice on Car audio for you.
|